Clone is dying, need advice

S

Scrapper420

Active Member
the clone sits in a humidity dome. IT all looked good till i checked it yesterday and it had this white fuzzy stuff on it. I researched the problem and discovered it was MOLD. The clone is wilting very bad and i need help to make it good again. Also, the leafs are still green but it looks like the green is disintegrating. Ive read a few sites, then made this solution(diluted baking soda and hydrogen peroxide in water) Ive sprayed this solution on the clone and in no time, the mold was out. The clone is still wilting right now.

Its my last chance to grow, i dont have any sources of clones or seeds where i live. Help is appreciated thanks
 
fantasticof

fantasticof

Active Member
dude ithe exact same shit happened to me last week... i got mold then use an antifungal spray left the dome off for allitle while put it back on, and the next day i had a bunch of little dead clippings.. my clones lived for 2 weeks and never got roots. sucks trist me i know
 
smokablunt16

smokablunt16

Well-Known Member
my molded after 4...i never had dome over it just had the cup it was in covered wit plastic wrap..seems to be doing just fine though
 
S

Scrapper420

Active Member
were the leafs looking dead ? and almost looking like their about to rot?
mine is wilting.. it makes the stem look like a string
 
BigBudBalls

BigBudBalls

Well-Known Member
Do the domes have any holes in them? A hole or two to let some stale air out might be in order.

I've had mold and every other clone prob. I've used nothing on the mold and just adjusted the humidity level and it cleared up and plants lived.
 
You must log in or register to reply here.
Top