did i clone right?????

i cloned one of my plants and i took cuttings from different parts of the plant....

4 of them were from shoots growing from branches connected from the stem.. they were pretty thin and weren't hollow inside,
one of them was from one of the branches connected from the main stem, i just counted like 4 nodes from top and then cut this one was hollow inside.

i cut them dipped in Rootech gel and into RW cubes soaked in PH 5.5 water with thrive alive red. cut the leaves in half

the Humidity in the dome is about 88% but all of the clones are wilted 90degrees over, is this pretty normal?

will the thinner clones do ok or should i have cut only the thicker branches that were hollow inside?

hey bud, did you scrape the stems before you dipped em?they wilt for day or 2. thinner 1 should be ok....peace

if you are STOP, only spray inside of dome when needed, not plants...peace

unlucky said:

​are you spraying them with water ?

Click to expand...

i did once.... am i not supposed to? ive been just spraying the floor and the dome

thats ok, just dont spray the cuts. you can foliar feed once established if you wish...peace

I always try to take clones from the bottom of the plant there the oldest and I've always had good success. The wilt happens you basically cut the plants arm off and are asking it to grow a new body from arm so shock may occur. It will better in a few days also advanced nutes makes a product called piranha it works great for clones just put a couple drops in the hole of cloning medium and good to go