RDCustoms
New Member
Howdy all,
If this is in the wrong section my fault, did not know where to post.
First time grower here, did a shit tonne of research, set myself up, ready to go.....only to be discouraged or let down by my own mistakes. So im mainly after any advice, tips or tricks to help a newb out haha
Seeds:
- OG Kush Auto (Kera Seeds)
- Gelato Auto (Fast Buds)
Setup:
- Mars Hydro 1m x 1m x 1.8m tent
- Mars Hydro 4" inline fan with carbon filter (ducted to roof)
- Mars Hydro FC-E3000 300w LED
- Oscilating Fan
- old baby monitor
- AC Infinity CloudForge T3 V2 Humidifier
Growing Medium:
Green Planet Pro Coco Perlite (70/30)
Nutes:
All Nutrients are Emerald Harvest.
- Cali Pro Grow A & B
- Cali Pro Bloom A & B
- Emerald Goddess (plant tonic)
- King Kola (bloom booster)
- Honey Chome (aroma and resin enricher)
Both seeds sat in a starter kit with lid and they went good in there, as the true leave came i took the lid off and they grew a bit more.
Then as i researched i realised Autos hate transplanting.....but i did it anyway....first mistake. Into 17L Fabric pots... Once in they seamed un happy, i think i may of put a wee bit too much water in but ahh well first grow, gotta learn as i go.
They both kinda stopped.....then they started trying to tell me something.
OGK was starting to turn pale and droop.
Gelato severaly drooped and the top of the seedling started to bend over alot.... only to realise i had my LED set to fucking 100%
Poor little buggers i damn near cooked them.
That is my second lesson.
So raised the LED up around 600mm or 23" @ 45%.
So as it is Winter here in Australia, cold as fuck. So i then needed to heat my tent when lights are off....so temp solution was a fan heater....lecci bill is gonna be bad this month haha
"Day" Temps LED @ 50% + heater 24-26°C with rh @ 70%. Have since dropped that too 60% to help pots dry a little, and they are into 2nd week of seedling.
"Night" Temps 19-20°C with rh @ 60-70%
Tomorrow i pick up some more gear
Heat Tube, Thermostat, temp/hum. sensor, PH test pen, PH up, PH down.
Dug around the coco to see if still wet or not...top layer was dry but under was still a bit moist so i feel i may have it a bit wet....so pumping the heat when the lights are on to help dry it a little.....then i gave them a very light feed to see if they will purk up as both of them have yellow baby leaves.
I did a 50% mix of the manufactures guide and syringed them a few drops each 5-6ml.
My questions are.....can they recover from all the mistakes to date.... if so what can i do to give them a shot.
I have dismissed yeild expectations and more focused on this being a full cycle lesson so the next time around i will be more prepared with knowledge.
Thanks in advance, and excuse the novel, i am wired different by 4 letters, ADHD
Cheers
If this is in the wrong section my fault, did not know where to post.
First time grower here, did a shit tonne of research, set myself up, ready to go.....only to be discouraged or let down by my own mistakes. So im mainly after any advice, tips or tricks to help a newb out haha
Seeds:
- OG Kush Auto (Kera Seeds)
- Gelato Auto (Fast Buds)
Setup:
- Mars Hydro 1m x 1m x 1.8m tent
- Mars Hydro 4" inline fan with carbon filter (ducted to roof)
- Mars Hydro FC-E3000 300w LED
- Oscilating Fan
- old baby monitor
- AC Infinity CloudForge T3 V2 Humidifier
Growing Medium:
Green Planet Pro Coco Perlite (70/30)
Nutes:
All Nutrients are Emerald Harvest.
- Cali Pro Grow A & B
- Cali Pro Bloom A & B
- Emerald Goddess (plant tonic)
- King Kola (bloom booster)
- Honey Chome (aroma and resin enricher)
Both seeds sat in a starter kit with lid and they went good in there, as the true leave came i took the lid off and they grew a bit more.
Then as i researched i realised Autos hate transplanting.....but i did it anyway....first mistake. Into 17L Fabric pots... Once in they seamed un happy, i think i may of put a wee bit too much water in but ahh well first grow, gotta learn as i go.
They both kinda stopped.....then they started trying to tell me something.
OGK was starting to turn pale and droop.
Gelato severaly drooped and the top of the seedling started to bend over alot.... only to realise i had my LED set to fucking 100%

Poor little buggers i damn near cooked them.
That is my second lesson.
So raised the LED up around 600mm or 23" @ 45%.
So as it is Winter here in Australia, cold as fuck. So i then needed to heat my tent when lights are off....so temp solution was a fan heater....lecci bill is gonna be bad this month haha
"Day" Temps LED @ 50% + heater 24-26°C with rh @ 70%. Have since dropped that too 60% to help pots dry a little, and they are into 2nd week of seedling.
"Night" Temps 19-20°C with rh @ 60-70%
Tomorrow i pick up some more gear
Heat Tube, Thermostat, temp/hum. sensor, PH test pen, PH up, PH down.
Dug around the coco to see if still wet or not...top layer was dry but under was still a bit moist so i feel i may have it a bit wet....so pumping the heat when the lights are on to help dry it a little.....then i gave them a very light feed to see if they will purk up as both of them have yellow baby leaves.
I did a 50% mix of the manufactures guide and syringed them a few drops each 5-6ml.
My questions are.....can they recover from all the mistakes to date.... if so what can i do to give them a shot.
I have dismissed yeild expectations and more focused on this being a full cycle lesson so the next time around i will be more prepared with knowledge.
Thanks in advance, and excuse the novel, i am wired different by 4 letters, ADHD
Cheers
