ok buddy
is this going to be the premit room/area for your growing or is this just a mid step allowing u to gain cash for a larger set up elsewhere
u got alot of it going right but missing a few key things
1 your walls/floor/ceiling...............u want a reflective surface so u gain all u can out of the light
look into some panda film/roll u use double sided tape and put the black against the walls and white to refect in ...........they have a zipper set u can apply to
this is to help get stronger plants and make the venting more effective.............now that u have it sealed in that area u can cut your venting points out ............with your hood system u can use a inline can fan and some flexie ducting ..........u need to know the size of the hook on to the vent (normal is 6 to 8 inches ) check this
ok the intake for it
u want to have this low to the ground and on the other side of the vent (if u are sucking the air out of the tent at the upper right front part of the tent....u want the intake in the lower back left of tent............this is where u would place the ac venting in point and a little fan to move it all around
the exhust is the inline can fan
looks like this one u have it attached to one end of the hood the other end the air is being sucked tho cooling the light and the air ...........pass tho the fan and out the back with more ducting to where ever u want it (best to expell out of the house or in attic)
u e get a varible speed controller (it is a plug thinglinked in amzon on most inline fans u look at) this will lower the speed of the fan and let some heat build up if u need it in winter or keep it on high and a stead ac for year round controll