10x10 Sealed Room Design Rehaul

Anyone have experience or preference with automated PH controllers / doser units?

I’ve never used them, always relied on the once a week manual route. I’m looking to put things into cruise control as much as possible now that my lifestyle has drastically changed therefore so just my growing style.

Again open to all suggestions and thoughts

Happy growing

I have used automated pH controllers in the past with great success. The only thing I can say to watch out for is a bad pH probe can cause a runaway dosing situation. Also good to have a spare tube for the pump as they eventually wear out and crack between the rollers.

Renfro said:

I have used automated pH controllers in the past with great success. The only thing I can say to watch out for is a bad pH probe can cause a runaway dosing situation. Also good to have a spare tube for the pump as they eventually wear out and crack between the rollers.

Click to expand...

Sounds good thanks for the heads up! Any device in specific you can recommend?

Bluelab makes some that are ok for a budget option. Agrowtek makes some that are nice but costly. For just basic pH dosing I would go with a Bluelab

https://hydrobuilder.com/garden-care-pest-control/grow-room-meters-and-testing-supplies/nutrient-dosers/complete-nutrient-ph-dosing-kits/bluelab-ph-controller-auto-doser.html

After much debate I’ll be sticking with only a flower room but focus on building out two walls and a ceiling within the existing shed.

I figure I can utilize some vertical racks with LEDs to do my minimal veg.

Open to thoughts and input!

Happy growing

Dougs Nugs said:

After much debate I’ll be sticking with only a flower room but focus on building out two walls and a ceiling within the existing shed.

I figure I can utilize some vertical racks with LEDs to do my minimal veg.

Open to thoughts and input!

Happy growing

Click to expand...

Can never have too much room in flower,

Dougs Nugs said:

After much debate I’ll be sticking with only a flower room but focus on building out two walls and a ceiling within the existing shed.

I figure I can utilize some vertical racks with LEDs to do my minimal veg.

Open to thoughts and input!

Happy growing

Click to expand...

thiis is fun
i sawl your area and the post alot of it is right but a few tweaks will get better results C02 and all

the whole shed u need to get some polywrap comes in 20x100ft 6mil thick in one piece u need to wrap the walls pressing up and sealing it with duct tape /staples/caulking leave the extra on the floor allowing u to use one sheet again and seal the 2 together .....cut out the door way and then seal the sheet to the wall do the same with any other openings........if u can keep any ac or openings high up ) then it is just matter of the door a good weather sealing will do the trick


divide the room in half one side flower one side veggie ......i got 6x10 foot flower 4x5 veggie and 4x5 work storage main door in on veggie work with a second pocketed slide door for flower
now tho the walls u will have a S bend top and bottom of the wall (honestly with your size u need 10 inches 4 of them with 2 booster fans ..... the S bend in the tube will stop light leak but it will pass Co2/cool air and oxygen/hot air between the rooms allowing one AC and Co2 supply ...........not i would place one booster on the lower vent point and one a high vent (u know one top left one lower right)